SCOTT MODEL 2011 TENDER BLEND MIXER 12'x2'x9'  100 hours used - Stainless Steal

Description

SCOTT MODEL 2011 TENDER BLEND MIXER
12'x2'x9'
>100 hours used - Stainless Steal
Less than 100 hours of use! Item can be shipped - buyer is responsible for shipping fees.
The tub measures 20” wide x 132” long. The agitator has a displacement of 22 cubic feet. Using 45-50% of the total displacement provides an efficient blending capacity of 10 to 11 cubic feet.
CONSTRUCTION:
The blender end plates are ¼” with a ¼” thick blender tub. All welded construction with 304 stainless steel provided on all product contact points.The blender exterior is finished with Steel-It industrial enamel unless otherwise specified. The blender interior has a mill finish unless a polished finish is specified.
The level of polish will affect pricing.
AGITATOR:
Constructed using a solid 304 SS steel main shaft. The shaft is fitted with adjustable“clamp-on” paddles supported by 1 1/8” diameter support posts welded to the main shaft.
For purposes of the initial quote clamp on style paddles are offered. For ease of cleaning and reduction of carry-over, threaded adjustable paddles with sanitary or jam nuts are also available in the event color changes require cleaning the machine prior to each run.
TOP COVER:
304SS 12 gauge quick release top cover. Each section has a closed cell foam gasket and is held in place using “Destaco” style clamps.
INLETS:
(1)Flanged product inlet for salt.
(1) 304SS LIQUID MANIFOLD:
(1) manifold for a mixture liquid dye, liquid calcium and others. The main header has threaded fitting in the center and two threaded end caps to allow for a variety of plumbing options. (3) threaded blender inlets extend from the main header through the sidewall of the tub near the dry product inlet. Each inlet to include a 60° fan style stainless steel nozzle.
PUMPS,CONTROLS & METERS:
(1) liquid pump with meter and a FC1000 central flow control station. The estimated 15’ length of run, rate of inclusion, product viscosity & other variables to be confirmed.
All transfer piping, pipe fittings and supports to be supplied by others as equipment is field fit.
DISCHARGE:
(1) 10” x 20” Flanged product discharge.
Actual dimensions may be determined by the take away equipment inlet dimensions
SHAFT SEALS:
Packing gland type seals constructed of 304SS. The seals include multiple rings of graphite packing gland material. The seal on the inlet end to include 3 rings of packing, a UHMW lantern ring and air purge fitting with gauge. The seal on the discharge and plate to have (2) rings of packing for dust control.
BEARINGS:
Supported by outboard bearing shelves are (1) heavy-duty 3 15/16” pillow block bearing on the drive end and (1) 3 7/16” pillow block on the idle end.
BLENDER STAND:
Carbon steel blender stand would be designed to support the blender above a take away or holding equipment. The stand height is estimated at 36”.Actual height to be determined which may affect pricing.
DRIVE ASSEMBLY (A Class II Rating): FINAL MIXER SPEED... 45 RPM
25 HP rated 1.7 service factor V-belt drive with OSHA carbon steel guard.
25 HP rated Dodge TAII 6307 shaft mount type 1.4 service factor reducer.
25 HP Premium Efficient TEFC 3ph/60hz/230-460v1800 rpm 1.15 service factor motor.
25 HP rated adjustable motor mounts.
25 HP Vacon NEMA 4X 30HP variable torque/25HP constant torque Variable Frequency Drive.